Collision Diagnosis

COLLISION DIAGNOSIS

To repair the SRS "AIR BAG", perform the following steps.

(1) Check the control unit (diagnostic unit).
- Connect CONSULT and then erase the memory. (However, the memory may not be cleared.)

OR

- Check "AIR BAG" warning lamp and perform the following twice: turn driver's door switch ON and OFF 5 times within 7 seconds after ignition switch turned "ON".
"AIR BAG" warning lamp comes on continuously.
Replace the control unit.
(2) Remove the deployed air bag module.
(3) Check the SRS components using the table shown below:
- If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.
(4) Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly except open circuit of air bag module.
(5) Install new air bag module.