Adjustment of Input Shaft Braking Mechanism

1. Install striking lever & rod, striking interlock assembly and control bracket on clutch housing exactly.

Note: When installing control bracket on clutch housing, assure protrusion beneath bracket is correctly seated.




2. Measure maximum height "H" while shifting from neutral to reverse position.
Maximum height "H":
67.38 - 67.86 mm (2.6528 - 2.6716 in)




3. Measure clearance "C" between reverse brake cam and striking lever while shifting to reverse position.

Clearance "C":
0.05 - 0.20 mm (0.0020 - 0.0079 in)

If "H" or "C" is not within specification, replace the following parts as a set.
- Striking lever assembly
- Striking interlock assembly (This includes reverse brake cam.)
- Control bracket assembly