Control Valve Assembly and Accumulator

CONTROL VALVE ASSEMBLY AND ACCUMULATOR

Removal

- RL4F03A & RE4F03V -





1. Drain ATF from transaxle.
2. Remove oil pan and gasket.








3. Disconnect A/T solenoid harness connector.





4. Remove stopper ring from A/T solenoid harness terminal body.
5. Remove All solenoid harness by pushing terminal body into transmission case.

RL4F03A -








6. Remove control valve assembly by removing fixing bolts.
- Be careful not to drop manual valve, tube connector, tubes and servo release accumulator return spring.
7. Disassemble and inspect control valve assembly if necessary - Refer to "REPAIR FOR COMPONENT PARTS".








- RE4FO3V -
6. Remove control valve assembly by removing fixing bolts.
- Be careful not to drop manual valve and servo release accumulator return springs.
7. Disassemble and inspect control valve assembly if necessary - Refer to "REPAIR FOR COMPONENT PARTS".

- RL4FO3A & RE4FO3V -





8. Remove servo release and N-D accumulators by applying compressed air if necessary.
- Hold each piston with a rag.





Installation
- Set manual shaft in Neutral position, then align manual plate with groove in manual valve.
- After installing control valve assembly to transmission case, make sure that selector lever can be moved to all positions.