Rear Suspension Assembly

Fig. 4 Rear Suspension Assembly Replacement.:

1. Disconnect ABS sensor and move away from rear suspension assembly, then remove exhaust pipe, propeller shaft rear end and disconnect parking brake cable.
2. Remove brake caliper assembly and suspend on wire.
3. Remove rear parcel shelf, then remove upper shock absorber nuts. Do not remove piston rod lock nut.
4. Remove suspension member mounting nuts, Fig. 4.
5. Draw out rear axle and suspension assembly.
6. Before removing any suspension component, put matchmarks on adjusting pin.
7. Reverse procedure to install, noting following:
a. Final tightening must be done with curb weight on wheels, on ground.
b. After installation, check wheel alignment.