CONSULT Inspection Procedure

Data Link Connector For Consult:

CONSULT INSPECTION PROCEDURE
1. Turn off ignition switch.

Consult Hookup:

2. Connect "CONSULT" to data link connector for CONSULT. (Data link connector for CONSULT is located in left dash side panel.)
3. Turn on ignition switch.

Consult Start Start Menu:

4. Touch "START".

Consult Engine/AT Menu:

5. Touch "ENGINE".

Consult Inspection Menu:

6. Perform each diagnostic test mode according to the inspection sheet

Consult Diagnostic Test Worksheet:

INSPECTION SHEET