Engine: Service and Repair

1. Release fuel system pressure as outlined under Technician Safety Information.
2. Remove hood and disconnect battery ground cable.
3. Disconnect vacuum and fuel hoses, wires, harnesses, electrical connectors and linkages. Mark hoses and electrical connectors for installation reference.
4. Drain engine coolant from cylinder block and radiator.
5. Remove radiator, fans and coupling, then the drive belts.
6. Remove alternator, air conditioning compressor and power steering pump.
7. Raise and support, then drain engine oil.
8. Remove exhaust pipes and drive shafts, if necessary.
9. Remove ball joints.
10. Attach suitable lifting equipment to engine and support transaxle with a suitable jack.
11. Remove left and right rear engine mounts.
12. Remove center member, then slowly lower transaxle jack and remove engine and transaxle from under vehicle.
13. Reverse procedure to install.