Collision Diagnosis

COLLISION DIAGNOSIS





To repair the SRS "AIR BAG", perform the following steps

When air bag deployed in a collision:

1. Replace the diagnosis (control) unit.
2. Remove the air bag module.
3. Check the SRS components using the table shown below:
- If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.

4. Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly except open circuits of air bag module.
5. Install new air bag module.
6. Conduct self-diagnosis again.

When air bag did not deploy in a collision:

1. Check the SRS components using the table shown below:
- If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.

2. Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly.