Control Cable Adjustment

CONTROL CABLE ADJUSTMENT
Move selector lever from the "P" position to the "1" position. You should be able to feel the detents in each position. If the detents cannot be felt or the pointer indicating the position is improperly aligned, the control cable needs adjustment.

1. Place selector lever in "P" position.
2. Loosen control cable lock nut and place manual shaft in "P" position.
3. Pull control cable in the direction of the arrow shown in the illustration by specified force.

Specified force: 6.9 N (0.1 kg, 1.5 lb)

4. Return control cable in the opposite direction of the arrow for 1.0 mm (0.039 in).
5. Tighten control cable lock nut.
6. Move selector lever from "P" position to "1" position and make sure that selector lever can be moved smoothly and without any sliding noise.
7. Apply grease to contacting areas of selector lever and control cable. Install any part removed.