Total End Play

ADJUSTMENT 2
When any parts listed in the following table are replaced, total end play or reverse clutch end play must be adjusted.

TOTAL END PLAY





- Measure clearance between reverse clutch drum and needle bearing for oil pump cover.
- Select proper thickness of bearing race so that end play is within specifications.





1. Measure dimensions "K" and "L" and then calculate dimension "J".





a. Measure dimension "K".





b. Measure dimension "L".
c. Calculate dimension "J".
"J": Distance between oil pump fitting surface of transmission case and needle bearing mating surface of high clutch drum.
J= K-L

2. Measure dimension "M".





a. Place bearing race and needle bearing on oil pump assembly.





b. Measure dimension "M".
"M": Distance between transmission case fitting surface and needle bearing on oil pump cover.
"M1": Indication of gauge.





c. Measure thickness of straightedge "t".
M = M1 - t

3. Adjust total end play "T3".

T3 = J - M
Total end play "T3": 0.25- 0.55 mm (0.0098 - 0.0217 in)

- Select proper thickness of bearing race so that total end play is within specifications.

Bearing races: Refer to SDS.