Disassembly

DISASSEMBLY





1. Check operation of high clutch.
a. Apply compressed air to oil hole of input shaft.
- Stop up a hole on opposite side of input shaft.
b. Check to see that retaining plate moves to snap ring.
c. If retaining plate does not move to snap ring, D-ring or oil seal may be damaged or fluid may be leaking at piston check ball.





2. Remove seal rings from input shaft.





3. Remove snap ring.
4. Remove drive plates, driven plates, retaining plate and dish plate.





5. Set Tool on spring retainer and remove snap ring from high clutch drum while compressing return springs.
- Set Tool directly above springs.

- Do not expand snap ring excessively.
6. Remove spring retainer and return springs.





- Do not remove return spring from spring retainer.





7. Remove piston from high clutch drum by turning it.





8. Remove D-ring and oil seal from piston.