Assembly

ASSEMBLY




1. Install D-ring and oil seal on piston.
- Cake care with the direction of the oil seal.
- Apply ATF to both parts.





2. Install piston assembly by turning it slowly.
- Apply ATF to inner surface of drum.





3. Install return springs and spring retainer on piston.





4. Set Tool on spring retainer and install snap ring while compressing return springs.
- Set Tool directly above return springs.





5. Install drive plates, driven plates, retaining plate and dish plates.
- Do not align the projections of any two dish plates.
- Take care with the order and direction of plates.





6. Install snap ring.





7. Measure clearance between retaining plate and snap ring. If not within allowable limit, select proper retaining plate.

Specified clearance:
Standard: 0.5 - 0.8 mm (0.020 - 0.031 in)
Allowable limit: 1.2 mm (0.047 in)
Retaining plate: Refer to SDS.





8. Check operation of reverse clutch.
Refer to "DISASSEMBLY" in "Reverse Clutch".