Keyless Entry: Service and Repair

If the remote controller or the control unit needs to be replaced or if an additional remote controller needs to be set, enter the identity (ID) code manually.
ID Code Entry Procedure
To enter the ID code, follow this procedure:
"Setting mode":
Three steps must be followed to establish the "setting mode".
1. Close and lock all doors.
2. Insert and remove the key from the ignition more than six times within 10 seconds. (The hazard warning lamp will then flash twice.)
^ At this time, the original ID codes are eliminated.
3. Turn ignition key to "ACC" position.

ID code entry:
4. Push the lock button on the new remote controller once.
^ At this time, the new ID code is entered. (The hazard warning lamp will then flash twice.)
5. To enter additional remote controllers (including the original) unlock, then lock, the driver's door with the door lock/unlock switch LH (in main power window switch).
6. Push lock button on the new additional remote controller once.
7. This ID code entry enable state and setting mode remain until the driver's door is opened.

NOTE
^ If the same ID code already exists in memory, the entry is canceled, and no ID code will be entered.
^ Entry of maximum four ID codes is allowed and any attempt to enter more will be ignored.
^ Any ID codes entered after termination of the "setting" mode will not be accepted. Additionally, remote control signals will be inhibited when an ID code has not been entered during "setting" mode.