Passenger Air Bag Module

Removal - Front Passenger Air Bag Module

CAUTION: Before servicing SRS, turn the Ignition switch off, disconnect battery ground cable and wait for at least 10 minutes.





1. Remove connector bracket from air bag module and disconnect inflator connector from body harness air bag connector.
2. Remove instrument panel.





3. Remove the special bolts from left and right sides of front passenger air bag module. Then remove the air bag module from the steering member.
- Air bag module is heavy and should be supported using both hands during removal.








CAUTION:
- Always place air bag module with pad side facing upward.
- Do not attempt to disassemble air bag module.
- The special bolts are coated with bonding agent. Discard old ones after removal; replace with new ones.
- Do not drop or impact air bag module. If any portion is deformed or cracked, replace the module.
- Do not expose the air bag module to temperatures exceeding 93°C (199°F).
- Do not allow oil, grease or water to come in contact with the air bag module.

Installation - Front Passenger Air Bag Module





1. Install front passenger air bag module on steering member.
- Ensure harness is not caught between rear of air bag module and steering member.
2. Install instrument panel.





3. Connect air bag module connector to body harness connector.
4. Install air bag module connector on connector bracket.
5. Install connector bracket on air bag module.