With Consult Scan Tool

SELF-DIAGNOSIS USING CONSULT

Operation procedure

The self-diagnosis results can be read by CONSULT, as follows:






1. Connect "CONSULT" to vehicle harness connector.

2. Turn ignition switch to "ON". (When CONSULT is connected, the "AIR BAG" warning lamp will be turned to present diagnosis mode.)






3. Touch "START" to operate "CONSULT".

4. Touch "AIR BAG" to choose air bag system.

5. Touch "SELF DIAG RESULTS" to read self-diagnosis results.

6. Problem codes are displayed on "SELF DIAG RESULTS".

7. When "PRINT" is pressed, information displayed on "SELF DIAG RESULTS 1 and 2" is printed out.






WARNING:

- While CONSULT is displaying this "SELF-DIAG RESULTS" Information, do not disconnect CONSULT from data link connector.

- When finishing diagnosis, make sure to change CONSULT display to SELECT SYSTEM mode by using BACK KEY.

8. After repairing malfunctioning parts, press "ERASE" to clear self-diagnosis results.

- "ERASE" function requires selecting "ERASE", and completing step 9.

9. Push Back Key of CONSULT until SELECT SYSTEM mode appears to make "SELF-DIAGNOSIS" user mode.

- If malfunctioning parts are not completely repaired, "AIR BAG" warning lamp will blink every 0.5 seconds.

10. Push the power off switch.

11. Turn off ignition switch, disconnect CONSULT.

12. Turn ignition switch to "ON".

"AIR BAG" warning lamp should come on for about 7 seconds and then go off.

Consult Diagnostic Code Chart:

SELF-DIAGNOSIS RESULTS