Air Bag Control Module: Service and Repair

Removal and Installation - Diagnosis Sensor Unit

CAUTION:
- Before servicing SRS, turn the Ignition switch off, disconnect battery ground cable and wait for at least 10 minutes.
- The special bolts are coated with bonding agent. Discard old ones after removal; replace with new ones.
- Check diagnosis sensor unit for proper installation.
- Check diagnosis sensor unit to ensure they are free of deformities, dents, cracks or rust. If they show any visible signs of damage, replace them with new ones.
- Check diagnosis sensor unit brackets to ensure they are free of deformities or rust.

1. Disconnect driver and passenger air bag module connectors.
2. Remove rear seat assembly. Refer to "Rear Seat".
3. Remove cover.
4. Disconnect diagnosis sensor unit connector.
5. Remove bolt and also remove special bolts using the torx bit, from diagnosis sensor unit.
Then remove the diagnosis sensor unit.

NOTE: To install, reverse the removal procedure sequence.