PPG Procedure
Bumper Cover Preparation PUR or PP1. Wash the bumper cover with soap and water.
2. Wet sand thoroughly with # 400 grit paper.
3. Scuff sand with gray Scotchbrite pad and abrasive cleaner.
4. Rinse thoroughly and dry.
5. Re-clean with DX-103.
6. Tack off surface.
To apply paint to the bumper cover, follow the procedure listed below based upon bumper cover material type.
Coating PUR (Polyurethane) bumper covers
7. Apply 1 coat of DP Epoxy Primer as a sealer and allow to dry.
Mix 1 part DP to 1 part DT Reducer to 1 part DP-401 (1:1:1).
8a. NON basecoat/clearcoat colors
Apply 2 coats or to hiding of DCC CONCEPT color using DT reducer, DU Hardener and DX-369 FLEXATIVE.
8b. Basecoat/clearcoat colors
Apply basecoat color and allow to dry.
Use either DBU color reduced with DRR reducer.
or
Use DBC color reduced with DT reducer.
9. Apply 2 coats of DCU-2001 or DCU-2020 clearcoat mixed with DT reducer, DU hardener and DX-369 FLEXATIVE.
Coating PP (Polypropylene) bumper covers
7. Apply 1 coat of DPX-800 Polypropylene Primer and allow to dry.
8a. NON basecoat/clearcoat colors
Apply 2 coats or to hiding of DCC CONCEPT color using DT reducer, DU Hardener and DX-369 FLEXATIVE.
8b. Basecoat/clearcoat colors
Apply basecoat color and allow to dry.
Use either DBU color reduced with DRR reducer.
or
Use DBC color reduced with DT reducer.
9. Apply 2 coats of DCU-2001 or DCU-2020 clearcoat mixed with DT reducer, DU hardener and DX-369 FLEXATIVE.