Collision Diagnosis

Collision Diagnosis







To repair the SRS "AIR BAG", perform the following steps.

When air bag deploys in a collision:

1. Replace the diagnosis sensor unit.
2. Remove the air bag modules.
3. Check the SRS components using the table shown above:

If any damage is visible (such as dents, cracks or deformation), replace the damaged component.

4. Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp. Open circuits of air bag module will appear as problem codes. Ensure the remainder of the SRS is operating properly.
5. Install new air bag modules.
6. Conduct self-diagnosis again.

When air bag does not deploy in a collision:

1. Check the SRS components using the table shown above:

If any damage is visible (such as dents, cracks or deformation), replace the damaged component.

2. Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly.