Procedure 4

DIAGNOSTIC PROCEDURE 4 (with CONSULT)

Final checking after repairing SRS by using CONSULT - Diagnosis mode

1. After repairing SRS, connect both battery cables.





2. Connect CONSULT to Data link connector.
3. Turn ignition switch from "OFF" to "ON".





4. Touch "START".





5. Touch "AIRBAG".





6. Touch "SELF-DIAG [CURRENT]".





7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Touch "ERASE".

NOTE: Touch "ERASE" to erase problem (Trouble code) retained in memory. Otherwise, CONSULT will still sense problem in memory when step 13 (Air bag warning lamp operation check) is performed. As a result, the "AIR BAG" warning lamp will still indicate a malfunction in the system.





- If any problem code was displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 and repair malfunctioning part completely Procedure 2

8. Touch "BACK" key of CONSULT.





9. Touch "SELF-DIAG [PAST]".
1O. Check that no self-diagnostic failure is detected on "SELFDIAG [PAST]".
11. Touch "BACK" key of CONSULT until SELECT SYSTEM MODE appears, turn off CONSULT then disconnect CONSULT.
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1 to check SRS operation by using "AIR BAG" warning lamp with User mode Procedure 1