Disassembly and Assembly

Disassembly And Assembly:

1. Remove rear cover.
- Heat rear cover, using heat gun, to 50°C (90°F) above room temperature to prevent bearing damage.

Disassembly And Assembly:

2. Disconnect stator/diode.
- Cut diode terminals.
- Unsolder stator coil leads.
CAUTION:
Unsolder stator coil leads as fast as possible to avoid damaging diodes.
3. Remove stator and rotor.
4. Remove bearing retainer and bearing.
5. Assemble in reverse of disassembly.

Disassembly And Assembly:

- Insert stator coil lead into lower portion of diode terminal.
- Using pliers, crimp diode terminal around stator coil lead.
- Be sure stator coil leads do not protrude more than 3 mm (0.118 in.) past diode terminal.

Disassembly And Assembly:

- Solder stator coil lead and diode terminals.

CAUTION: Solder stator coil leads and diode terminals as fast as possible to avoid damaging diodes. Use 9/1 Pb/Sn solder in assembly.