Multi-Remote Control System

Power is supplied at all times
^ to smart entrance control unit terminal (1)
^ through 25 A fusible link (letter (i) located in the fusible link and fuse box).
Power is supplied at all times
^ to interior lamp terminal (1) and
^ to key switch terminal (1)
^ through 10 A fuse (No. (6) located in the fuse block).
Power is supplied at all times
^ to multi-remote control relays-1 and 2 terminal (1)
^ through 10 A fuse (No. (5) located in the fuse block).
Terminal (10) of the smart entrance control unit is grounded through body grounds (M5) and (M57).

INPUTS
When the key switch is ON (ignition key is inserted in key cylinder), power is supplied
^ through key switch terminal (2)
^ to smart entrance control unit terminal (24).
When the door switch LH is OPEN, ground is supplied
^ to smart entrance control unit terminal (15)
^ through door switch LH terminal (1)
^ to door switch LH terminal (3)
^ through body grounds (B4), (B13) and (T16).
When the door switch RH is OPEN, ground is supplied
^ to smart entrance control unit terminal (16)
^ through door switch RH body ground.
When the door lock actuator LH (door unlock sensor) is UNLOCKED, ground is supplied
^ to smart entrance control unit terminal (12)
^ through door lock actuator LH (door unlock sensor) terminal (4)
^ to door lock actuator LH (door unlock sensor) terminal (2)
^ through body grounds (M5) and (M57).
When the door lock actuator RH (door unlock sensor) is UNLOCKED, ground is supplied
^ to smart entrance control unit terminal (13)
^ through door lock actuator RH (door unlock sensor) terminal (4)
^ to door lock actuator RH (door unlock sensor) terminal (2)
^ through body grounds (M5) and (M57).
Remote controller signal input
^ through window antenna
^ to smart entrance control unit terminal (37).
The multi-remote control system controls operation of the
^ power door lock
^ interior lamp
^ panic alarm
^ hazard lamp
^ ID code entry.

OPERATED PROCEDURE
Power door lock operation
When the following input signals are both supplied:
^ key switch OFF (when ignition key is not inserted in key cylinder);
^ door switch CLOSED (when all the doors are closed);
smart entrance control unit locks all the doors with input of LOCK signal from remote controller.
Smart entrance control unit unlocks the doors with input of UNLOCK signal from remote controller.

Interior lamp operation
When the following input signals are both supplied:
^ key switch OFF (when ignition key is not inserted in key cylinder);
^ door switch CLOSED (when all the doors are closed);
multi-remote control system turns on interior lamp (for 30 seconds) with input of UNLOCK signal from remote controller.

Panic alarm operation
When key switch is OFF (when ignition key is not inserted in key cylinder), multi-remote control system turns on and off horn and headlamp intermittently with input of PANIC ALARM signal from remote controller.

Hazard lamp operation
When the following input signals are all supplied:
^ key switch OFF (when ignition key is not inserted in key cylinder);
^ door switch CLOSED (when all the doors are closed);
^ door lock actuator (door unlock sensor) LOCKED (when all the doors are locked);
multi-remote control system outputs the following ground signals with input of LOCK signal from remote controller:
^ to multi-remote control relays-1 and 2 terminal (2);
^ through smart entrance control unit terminal (7)
As a result, multi-remote control relay-1 is energized, and hazard warning lamps flash on and off.