Fuel Pump: Service and Repair

REMOVAL
1. Release fuel pressure from fuel line.
2. Remove inspection hole cover located behind the rear seat.
3. Disconnect harness connectors and fuel tubes on upper plate.
- Put mating marks on tubes for correct installation.




4. Remove lock ring (Use SST J38879-A).




5. While lifting upper plate, disconnect fuel tube and harness connectors.




6. Remove fuel pump pulling the top end of the fuel pump bracket upward.
7. Remove fuel gauge unit.
- Pull fuel gauge unit horizontally to the left.




- Remove harness connector.

NOTE: Carefully place the removed connector in the fuel tank so that it can be pulled out for the installation.

INSTALLATION
Installation is the reverse order of removal.




CAUTION: When installing upper plate, align the mark on it with the center of marks on fuel tank.