Removal

CAUTION: When removing the transmission assembly from engine, first remove the crankshaft position sensor (OBD) from the assembly. Be careful not to damage sensor edge and ring gear teeth.




1. Remove battery negative terminal.
2. Remove control lever with control housing from transmission.
3. Remove crankshaft position sensor (OBD) from upper side of transmission case.
4. Remove clutch operating cylinder from transmission.
5. Disconnect speed sensor, OD position switch, back-up lamp switch, rear heated oxygen sensor and neutral position switch harness connectors.
6. Remove starter motor from transmission.
7. Remove propeller shaft.
- Insert plug into rear oil seal after removing propeller shaft.
- Be careful not to damage spline, sleeve yoke and rear oil seal when removing propeller shaft.
8. Remove gussets from transmission or engine.
9. Remove exhaust tube mounting bracket from transmission.
10. Support manual transmission with a jack.
11. Remove rear mounting bracket.
12. Lower manual transmission as much as possible.




13. Remove transmission fixing bolts.
14. Remove transmission from engine.
- Support manual transmission while removing it.