Road Testing

ROAD TEST

Description




- The purpose of the test is to determine overall performance of A/T and analyze causes of problems.
- The road test consists of the following three parts: E
1. Check before engine is started
2. Check at idle
3. Cruise test




- Before road test, familiarize yourself with all test procedures and items to check.
- Conduct tests on all items until specified symptom is found. Troubleshoot items which check out No Good after road test. Refer to "How to Display and Read Diagnostic Trouble Codes".

1. Check before engine is started





2. Check at idle





3. Cruise Test




- Check all items listed in Parts 1 through 3.

With CONSULT
- Using CONSULT, conduct a cruise test and record the result.
- Print the result and ensure that shifts and lock-ups take place as per "Shift Schedule".

CONSULT Setting Procedure

DLC For CONSULT:

1. Turn off ignition switch.
2. Connect "CONSULT" to Data link connector for CONSULT Data link connector for CONSULT is located in left side dash panel.




3. Turn on ignition switch.
4. Touch "START".




5. Touch "A/T".




6. Touch "DATA MONITOR".




7. Touch "SETTING" to set recording condition.




8. Touch "LONG TIME" and "ENTER" key.




9. Go back to SELECT MONITOR ITEM and touch "MAIN SIGNALS".
10. Touch "START".




11. When performing cruise test, touch "RECORD".




12. After finishing cruise test part 1, touch "STOP".




13. Touch "DISPLAY".




14. Touch "PRINT".




15. Touch "PRINT" again.




16. Check the monitor data printed out.
17. Continue cruise test part 2 and 3.

Without Scan Tool



- Throttle position can be checked by voltage across terminals (34) and (35) of A/T control unit.

Cruise Test Part 1 (1):

Cruise Test Part 1 (2):

Cruise Test Part 2:

Cruise Test Part 3:

Shift Schedule

Vehicle Speed When Shifting Gears:

Vehicle Speed When Performing And Releasing Lock-up: