Component Testing Procedure

COMPONENT INSPECTION
FPCM

With Consult
1. Start engine and let it idle.










2. Perform "FPCM" in "ACTIVE TEST" mode with CONSULT.




3. Make sure of the following.
4. If NG, replace FPCM.

OR

Without Scan Tools
1. Start engine and warm it up sufficiently
2. Turn ignition switch "OFF" and wait for at least 5 seconds.
3. Start engine and let it idle.







4. Check voltage between terminals (1) and (2). The voltage should be within each of the following ranges at least one time within 60 seconds of starting engine.
5. If NG, replace FPCM.

CAUTION: Connect a suitable wire between the FPCM body and ground during inspection because the FPCM is body grounded type.