Wiper and Washer Systems: Service and Repair

Installation Front Wiper And Washer:

Installation Rear Wiper And Washer:

1. Prior to wiper arm installation, turn on wiper switch to operate wiper motor and then turn it "OFF" (Auto Stop).
2. Lift the blade up and then set it down onto glass surface. Set the blade center to clearance "C" or "D" immediately before tightening nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper motor and then turn it "OFF".
4. Ensure that wiper blades stop within clearance "C" & "D".
Clearance "C": 0 - 10 mm (0 - 0.39 in)
Clearance "D": 73 - 88 mm (2.87 - 3.46 in)
^ Tighten windshield wiper arm nuts to specified torque.
Front wiper:
26 - 32 N-m (2.7 - 3.3 kg-m, 20 - 24 ft-lb)

Installation:

^ Before reinstalling wiper arm, clean up the pivot area as illustrated. This will reduce possibility of wiper arm looseness.