Tightening Specifications

Refer to Technical Service Bulletin NTB 94-092
1. Tighten cylinder head bolts using the following procedure:
2. Tighten all bolts to 29 Nm (22 ft. lbs.).
3. Tighten all bolts another 79 Nm (59 ft. lbs.).
4. Loosen all the bolts completely.
5. Tighten all bolts to 25 - 34 Nm (18 - 25 ft. lbs.).
6. Turn all bolts 86 - 91° clockwise. If an angle wrench is not available, mark all cylinder head bolts on the side facing the engine front. Then, turn each cylinder head bolt 86 - 91° clockwise.