Procedure 2

Diagnostic Procedure 2 (With CONSULT)

Inspecting SRS malfunctioning parts by using CONSULT - Diagnosis mode

1. Turn ignition switch "OFF".






2. Connect "CONSULT" to Data link connector.

3. Turn ignition switch "ON".






4. Touch "START".






5. Touch "AIRBAG".






6. Touch "SELF-DIAG [CURRENT]".






7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".






If no self-diagnostic failure is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in DIAGNOSTIC PROCEDURE 1, go to DIAGNOSTIC PROCEDURE 6.

8. Touch "PRINT".

9. Compare diagnostic codes to the CONSULT DIAGNOSTIC CODE CHART.

10. Touch "BACK" key of CONSULT until SELECT SYSTEM appears, then turn oft CONSULT.

11. Turn ignition switch "OFF", then disconnect CONSULT and both battery cables.

"CONSULT" Code Chart:

12. Repair the system as outlined by the "Repair order" in CONSULT DIAGNOSTIC CODE CHART, that corresponds to the problem code.

13. After repairing the system, conduct DIAGNOSTIC PROCEDURE 2 again.

If repair is completed, turn ignition switch "OFF" and disconnect CONSULT. Then go to DIAGNOSTIC PROCEDURE 1.