Procedure 3

Diagnostic Procedure 3 (Without CONSULT)

Inspecting SRS malfunctioning parts by using "AIR BAG" warning lamp - Diagnosis mode

NOTE:
SRS will not enter Diagnosis mode if no malfunction is detected in User mode.

1. Open driver's door.
2. Turn ignition switch from "OFF" to "ON".





3. Press driver's door switch at least 5 times within 7 secondsafter turning ignition switch "ON".
SRS is now in Diagnosis mode.
4. "AIR BAG" warning lamp operates in diagnosis mode as follows:

NOTE:
If SRS does not enter diagnostic mode even though malfunction is detected in User mode, go to DIAGNOSTIC PROCEDURE 10.

Warning Lamp Flash Chart:

5. Malfunctioning part is indicated by the number of flashes (d).

Warning Lamp Flash Code Chart:

Compare the number of flashes to the WARNING LAMP FLASH CODE CHART, and locate malfunctioning part.
6. Turn ignition switch "OFF", and disconnect both battery cables.
7. Repair the system as outlined by "Repair order" in the WARNING LAMP FLASH CODE CHART that corresponds to the flash code.
8. After repairing the system, go to DIAGNOSTIC PROCEDURE 5.