Procedure 4

Diagnostic Procedure 4 (with CONSULT)

Final checking after repairing SRS by using CONSULT-Diagnosis mode

1. After repairing SRS, connect both battery cables.





2. Connect CONSULT to Data link connector
3. Turn ignition switch from "OFF" to "ON".





4. Touch "START".





5. Touch "AIRBAG".





6. Touch "SELF-DIAG [CURRENT]".





7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Touch "ERASE".

NOTE:
Touch "ERASE" to erase problem (Trouble code) retained in memory. Otherwise, CONSULT still senses problem in memory when step 13 (Air bag warning lamp operation check) is performed. The result is confusing a new with an old problem.





If any problem code was displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2, and repair malfunctioning part completely.

8. Touch "BACK" key of CONSULT.





9. Touch "SELF-DIAG [PAST]".





10. Check that no self-diagnostic failure is detected on "SELFDIAG (PAST)".
11. Touch "BACK" key of CONSULT until SELECT SYSTEM appears, turn oft CONSULT, then disconnect CONSULT.
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1 to check SRS operation by using "AIR BAG" warning lamp with User mode.