Control Valve Assembly and Accumulator

REMOVAL

- RL4F03A & RE4F03V -




1. Drain ATF from transaxle.
2. Remove oil pan and gasket.










3. Disconnect A/T solenoid harness connector.




4. Remove stopper ring from A/T solenoid harness terminal body.
5. Remove A/T solenoid harness by pushing terminal body into transmission case.

- RL4F03A -




6. Remove control valve assembly by removing fixing bolts.
- Be careful not to drop manual valve, tube connector, tubes and servo release accumulator return spring.

7. Disassemble and inspect control valve assembly if necessary.

- RE4F03V -



6. Remove control valve assembly by removing fixing bolts.
- Be careful not to drop manual valve and servo release accumulator return springs.
7. Disassemble and inspect control valve assembly if necessary.


- RL4F03A & RE4F03V -



8. Remove servo release and N-D accumulators by applying compressed air if necessary.
- Hold each piston with a rag.

INSTALLATION
- Tighten fixing bolts to specification
Tightening Torque : 7 - 9 N.m (0.7 - 0.9 kg.m, 61 - 78 in.lb)




- Set manual shaft in Neutral position, then align manual plate with groove in manual valve.
- After installing control valve assembly to transmission case, make sure that selector lever can be moved to all positions.