Procedure 4

Final Checking After Repairing SRS By Using CONSULT - Diagnosis Mode

Diagnostic Procedure 4 (with Consult):

1. After repairing SRS, connect both battery cables.
2. Connect CONSULT to data link connector.
3. Turn ignition switch from OFF to ON.

Diagnostic Procedure 4 (with Consult):

4. Touch START.

Diagnostic Procedure 4 (with Consult):

5. Touch AIRBAG.

Diagnostic Procedure 4 (with Consult):

6. Touch SELF-DIAG [CURRENT].

Diagnostic Procedure 4 (with Consult):

7. If no malfunction is detected on SELF-DIAG [CURRENT], repair of SRS is completed. Touch ERASE.

NOTE: Touch ERASE to clear problem (Trouble code) retained in memory. Otherwise, diagnosis sensor unit will still sense problem in memory when step 13 (Air bag warning lamp operation check) is performed. As a result, the "AIR BAG" warning lamp will still indicate a malfunction in the system.

Diagnostic Procedure 4 (with Consult):

^ If any problem code was displayed on SELF-DIAG [CURRENT], the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2, and repair malfunctioning part completely. Procedure 2

8. Touch BACK key of CONSULT

Diagnostic Procedure 4 (with Consult):

9. Touch SELF-DIAG [PAST].

Diagnostic Procedure 4 (with Consult):

10. Check that no self-diagnostic failure is detected on SELF-DIAG [PAST].
11. Touch BACK key of CONSULT until SELECT SYSTEM appears, turn off CONSULT, then disconnect CONSULT
12. Turn ignition switch OFF.
13. Go to DIAGNOSTIC PROCEDURE 1,to check SRS operation by using "AIR BAG" warning lamp with User mode. Procedure 1