Seals and Gaskets: Service and Repair
VALVE OIL SEAL1. Remove rocker cover.
2. Remove camshaft.
3. Remove valve spring and valve oil seal with Tool or a suitable tool.
- Piston concerned should be set at TDC to prevent valve from falling.
4. Apply engine oil to new valve oil seal and install it with Tool.
OIL SEAL INSTALLING DIRECTION
Install new oil seal in the direction shown.
FRONT OIL SEAL
1. Remove radiator shroud and crankshaft pulley.
2. Remove front oil seal.
- Be careful not to scratch front cover.
3. Apply engine oil to new oil seal and install it using a suitable tool.
REAR OIL SEAL
1. Remove drive plate or flywheel.
2. Remove rear oil seal retainer.
3. Use a scraper to remove all traces of liquid gasket from mating surface.
- Remove old liquid gasket from the bolt holes and threads.
4. Remove rear oil seal from rear oil seal retainer.
5. Apply engine oil to new oil seal and install it using a suitable tool.
6. Apply a continuous bead of liquid gasket to rear oil seal retainer.
- Use Genuine RTV silicone sealant Part No. 999MP-A7007,Three Bond TB1207D or equivalent.
- Apply a continuous bead of liquid gasket around inner side of bolt holes.