Procedure 2

Inspecting SRS Malfunctioning Parts By Using CONSULT - Diagnosis Mode

Diagnostic Procedure 2 (With Consult):

1. Turn ignition switch "OFF".
2. Connect "CONSULT" to Data link connector.

Diagnostic Procedure 2 (With Consult):

3. Turn ignition switch "ON".
4. Touch "START".

Diagnostic Procedure 2 (With Consult):

5. Touch "AIRBAG".

Diagnostic Procedure 2 (With Consult):

6. Touch "SELF-DIAG [CURRENT]".

Diagnostic Procedure 2 (With Consult):

7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]"

Diagnostic Procedure 2 (With Consult):

^ If no self-diagnostic failure is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected by the AIR BAG" warning lamp, go to DIAGNOSTIC PROCEDURE 6.

8. Touch "PRINT".
9. Compare diagnostic codes to the CONSULT DIAGNOSTIC CODE CHART.
10. Touch "BACK" key of CONSULT until SELECT SYSTEM appears, then turn off CONSULT.
11. Turn ignition switch "OFF", then disconnect CONSULT and both battery cables.
12. Repair the system as outlined by the "Repair order" in CONSULT DIAGNOSTIC CODE CHART that corresponds to the problem code. For replacement procedure of component parts.
13. After repairing the system, go to DIAGNOSTIC PROCEDURE 4.

Consult Diagnostic Code Chart:

CONSULT DIAGNOSTIC CODE CHART