Procedure 4

Final Checking After Repairing SRS By Using CONSULT - Diagnosis Mode

Diagnostic Procedure (4 With Consult):

1. After repairing SRS, connect both battery cables.
2. Connect CONSULT to Data link connector
3. Turn ignition switch from "OFF" to "ON".

Diagnostic Procedure (4 With Consult):

4. Touch "START".

Diagnostic Procedure (4 With Consult):

5. Touch "AIRBAG".

Diagnostic Procedure (4 With Consult):

6. Touch "SELF-DIAG [CURRENT]".

Diagnostic Procedure (4 With Consult):

7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Touch "ERASE".

NOTE: Touch "ERASE" to erase problem (Trouble code) retained in memory. Otherwise, CONSULT still senses problem in memory when step 13 (Air bag warning lamp operation check) is performed. As a result, the "AIR BAG" warning lamp will still indicate a malfunction in the system.

Diagnostic Procedure (4 With Consult):

If any problem code was displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 and repair malfunctioning part completely.

8. Touch "BACK" key of CONSULT

Diagnostic Procedure (4 With Consult):

9. Touch "SELF-DIAG [PAST]".

Diagnostic Procedure (4 With Consult):

10. Check that no self-diagnostic failure is detected on "SELF-DIAG [PAST]".
11. Touch "BACK" key of CONSULT until SELECT SYSTEM appears, turn off CONSULT, then disconnect CONSULT
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1 to check SRS operation by using "AIR BAG" warning lamp with User mode.