Stall Test Procedure

1. Check A/T and engine fluid levels. If necessary, add.
2. Drive vehicle for approx. 10 minutes or until engine oil and ATF reach operating temperature.
ATF operating temperature: 50 - 80° C (122 - 176° F)





3. Set parking brake and block wheels.
4. Install a tachometer where it can be seen by driver during test.
^ It is good practice to put a mark on point of specified engine RPM on indicator.
5. Start engine, apply foot brake, and place selector lever in "D" position.
6. Accelerate to wide-open throttle gradually while applying foot brake.
7. Quickly note the engine stall revolution and immediately release throttle.





^ During test, never hold throttle wide-open for more than 5 seconds. Stall revolution: 2,050 - 2,250 RPM





8. Move selector lever to "N" position.
9. Cool off ATF.
^ Run engine at idle for at least one minute.
10. Repeat steps 5 through 9 with selector lever in "2", "1" and "R" positions.