Manual Control Linkage Adjustment

Move selector lever from "P" position to "1" position. You should be able to feel the detentes in each position.
If no detentes are felt or the position pointer is not aligned properly, adjust the linkage.
1. Place selector lever in "P" position.




2. Loosen lock nuts.
3. Tighten lock nut (X) until it touches trunnion pulling selector lever toward "R" position side without pushing button.
4. Back off lock nut (X) 1 turn and tighten lock nut (Y) to the specified torque.

Lock nut:
11 - 15 Nm (1.1 - 1.5kg-m, 8 - 11 ft-lb)




5. Move selector lever from "P" position to "1" position. Make sure that selector lever can move smoothly.