Procedure 7
Inspecting SRS Intermittent Problem By Using CONSULT - Diagnosis ModeDiagnostic Procedure 7 (with Consult):
1. Turn ignition switch OFF.
2. Connect CONSULT to Data link connector.
Diagnostic Procedure 7 (with Consult):
3. Turn ignition switch ON.
4. Touch START
Diagnostic Procedure 7 (with Consult):
5. Touch AIRBAG.
Diagnostic Procedure 7 (with Consult):
6. Touch SELF-DIAG [PAST].
Diagnostic Procedure 7 (with Consult):
7. If diagnostic codes are displayed on SELF-DIAG [PAST], go to step 10.
Diagnostic Procedure 7 (with Consult):
If no self-diagnostic failure is detected on SELF-DIAG [PAST], touch BACK and go back to SELECT DIAG MODE.
Diagnostic Procedure 7 (with Consult):
8. Touch TROUBLE DIAG RECORD.
Diagnostic Procedure 7 (with Consult):
9. Diagnostic code is displayed on TROUBLE DIAG RECORD.
10. Touch PRINT
11. Compare diagnostic codes to the INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART. Trouble Code Description and Repairs
12. Touch BACK key of CONSULT until SELECT SYSTEM MODE appears, then turn off CONSULT
13. Turn ignition switch OFF, then disconnect CONSULT and both battery cables.
14. Repair the system as outlined by the Repair order in INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART, that corresponds to the problem code. For replacement procedure of component parts. Trouble Code Description and Repairs
15. Go to DIAGNOSTIC PROCEDURE 4. Procedure 4
Intermittent Problem Diagnostic Code Chart:
INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART