Seals and Gaskets: Service and Repair

VALVE OIL SEAL








1. Remove rocker cover.
2. Remove camshaft.
3. Remove valve spring and valve oil seal with Tool or suitable tool.
- Piston must be set at TDC to prevent valve from falling.

4. Apply engine oil to new valve oil seal and install it with Tool.

FRONT OIL SEAL





1. Remove radiator shroud and crankshaft pulley.
2. Remove front oil seal.
- Be careful not to scratch front cover.








3. Apply engine oil to new oil seal and install it using a suitable tool.
- Install new oil seal in the direction shown.

REAR OIL SEAL





1. Remove drive plate or flywheel.
2. Remove rear oil seal retainer.
3. Remove traces of liquid gasket using scraper.





4. Remove rear oil seal from rear oil seal retainer.
- Be careful not to scratch rear oil seal retainer.








5. Apply engine oil to new oil seal and install it using a suitable tool.
- Install new oil seal in the direction shown.





6. Apply a continuous bead of liquid gasket to mating surface of rear oil seal retainer.
- Use Genuine RTV silicone sealant Part No. 999MPA7007, Three Bond TB1207D or equivalent.
- Apply around inner side of bolt holes.