Procedure 4

Final Checking After Repairing SRS By Using CONSULT - Diagnosis Mode

Diagnostic Procedure 4 (with Consult):

1. Check that both battery cables are connected.
2. Connect CONSULT to Data link connector.
3. Turn ignition switch from OFF to ON.

Diagnostic Procedure 4 (with Consult):

4. Touch START.

Diagnostic Procedure 4 (with Consult):

5. Touch AIRBAG.

Diagnostic Procedure 4 (with Consult):

6. Touch SELF-DIAG [CURRENT].

Diagnostic Procedure 4 (with Consult):

7. If no malfunction is detected on SELF-DIAG [CURRENT], repair of SRS is completed. Touch ERASE.

NOTE: Touch ERASE to clear problem (Trouble code) retained in memory. Otherwise, CONSULT will still sense problem in memory when step 13 (Air bag warning lamp operation check) is performed. As a result, the "AIR BAG" warning lamp will still indicate a malfunction in the system.

Diagnostic Procedure 4 (with Consult):

^ If any problem code was displayed on SELF-DIAG [CURRENT], the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 and repair malfunctioning part. Procedure 2
8. Touch BACK key of CONSULT

Diagnostic Procedure 4 (with Consult):

9. Touch SELF-DIAG [PAST].

Diagnostic Procedure 4 (with Consult):

10. Check that no self-diagnostic failure is detected on SELF-DIAG [PAST].
11. Touch BACK key of CONSULT until SELECT SYSTEM MODE appears, turn oft CONSULT then disconnect CONSULT.
12. Turn ignition switch OFF.
13. Go to DIAGNOSTIC PROCEDURE 1 to check SRS operation by using "AIR BAG" warning lamp with User mode. Procedure 1