With M/T

WARNING: BE CAREFUL NOT TO BURN YOURSELF, AS THE ENGINE AND OIL MAY BE HOT.

NOTE: Put gearshift lever in Neutral "N" position.

1. Check oil level and fill to "Full" mark if needed.
2. Remove oil pressure switch.





3. Install pressure gauge.
4. Start engine and warm it up to normal operating temperature.
5. Check oil pressure with engine running under no-load:

At 3000 RPM: 435 - 551 (63.1 - 79.9 psi)
At idle speed: More than 69 kPa (10 psi).

If difference is extreme, check oil passage and oil pump for oil leaks.

6. Install oil pressure switch with sealant.