Self-Diagnosis Flow Chart

Self-Diagnosis










Checking Procedures

How to interpret the Results



STEP 1: Checks LEDs and segments
When switch's LED and segments are functioning properly in STEP 1, the LED and display will come on.




If LEDs or segments malfunction, LED will not come on or display will show incomplete segment.




STEP 2: Checks each sensor circuit for open or short circuit
Display shows "2" in STEP 2 mode.
Then all sensors are in good order, display shows "20".
It takes approximately 4 seconds to check all sensors.




If a sensor is malfunctioning, the corresponding code No. blinks on display. A short circuit is identified by a blinking "-" mark preceding mode number.




If two or more sensors malfunction, corresponding code Nos. respectively blink two times.




Sensors and abnormalities
If a circuit is opened or shorted, display shows its code No. when input corresponds with any of following conditions.




STEP 3: Checks mode and intake door positions
Display shows "3 "in STEP 3 mode.
When all doors are in good order, display will then show "30".
It takes approximately 20 seconds to check all mode and intake doors.










When abnormalities are detected, display shows a code No. corresponding with malfunctioning part.




STEP 4: Checks operation of each actuator







During inspection in STEP 4, the auto amp. will forcefully transmit an output to the affected actuators. The corresponding code Nos. are shown on display as indicated in the table below.
Checks must be made visually, by listening to any noise, or by touching air outlets with your hand, etc. for improper operation.
Operating condition of each actuator cannot be checked by indicators.




STEP 5: Checks temperature detected by sensors, and detects multiplex communication error
Checks temperature detected by sensors




If temperature shown on display greatly differs from actual temperature, check sensor circuit at first. Then inspect sensor itself according to the procedures described in Control System Input Component.







Detects multiplex communication error
Display shows "52" in STEP 5 mode.
[Multiplex communication error between push control unit and auto amplifier is detected]




CAUTION:
The auto amp. memorizes any communication error in the system in a normal control with battery connected. When there is an error, display will be as shown above. When plural errors occur, the display of each error will blink two times for 0.5 second intervals.
If a communication error is displayed, follow the flow chart below. Determine if the error occurred in the past or is currently happening.




AUXILIARY MECHANISM: Temperature setting trimmer