Removal

CAUTION:
^ Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait for at least 3 minutes.
^ Always work from the side of or under air bag module.

1. Open the glove box lid.

Removal - Front Passenger Air Bag Module:

2. Disconnect air bag module connector from body harness air bag connector.
3. Remove glove box assembly.

Removal - Front Passenger Air Bag Module:

4. Remove the bolts and special bolts using the TAMPER RESISTANT TORX (Size T50) from front passenger air bag module. Take out the air bag module from the instrument panel.
^ The air bag module is heavy and should be supported using both hands during removal.

Removal - Front Passenger Air Bag Module:

CAUTION:
^ Always place air bag module with pad side facing upward.
^ Do not attempt to disassemble air bag module.
^ The special bolts are coated with bonding agent. Do not use old bolts after removal; replace with new coated bolts.
^ Do not insert any foreign objects (screwdriver, etc.) into air bag module connector.
^ Replace air bag module if it has been dropped or sustained an impact.
^ Do not expose the air bag module to temperatures exceeding 90°C (194°F).
^ Do not allow oil, grease or water to come in contact with the air bag module.
^ After air bag inflates, the front instrument panel assembly should be replaced if damaged.