Air Bag Systems: Service Precautions

^ Do not use a circuit tester to check SRS circuits unless instructed.
^ Before servicing the SRS, turn ignition switch "OFF", disconnect both battery cables and wait for at least 3 minutes.
For approximately 3 minutes after the cables are removed, it is still possible for the air bag to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
^ Diagnosis sensor unit must always be installed with arrow marks "<=" pointing towards the front of the vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.
^ The spiral cable must be aligned with the neutral position since its rotations are limited. Do not attempt to turn steering wheel or column after removal of steering gear.
^ Handle air bag module carefully. Always place it with the pad side facing upward.
^ Conduct self-diagnosis to check entire SRS for proper function after replacing any components.
^ After air bag inflates, the front instrument panel assembly should be replaced if damaged.