Seals and Gaskets: Service and Repair

VALVE OIL SEAL





1. Remove rocker cover.
2. Remove camshaft.
3. Remove valve spring.
4. Remove valve oil seal with Tool.
Piston concerned should be set at TDC to prevent valve from falling.








5. Apply new engine oil to new valve oil seal and install it with Tool.

FRONT OIL SEAL





1. Remove the following parts:
- Engine under cover
- RH engine side cover
- Generator and power steering drive belts
- Crankshaft pulley

2. Remove front oil seal from front cover.
- Be careful not to scratch front cover.








3. Apply new engine oil to new oil seal and install it using a suitable tool.
- Install new oil seal in the direction shown.

REAR OIL SEAL





1. Remove flywheel or drive plate.
2. Remove rear oil seal retainer.
3. Remove traces of liquid gasket using scraper.
4. Remove seal from rear oil seal retainer.
- Be careful not to scratch rear oil seal retainer.








5. Apply new engine oil to new oil seal and install it using a suitable tool.
- Install new oil seal in the direction shown.