Procedure 8
Inspecting SRS Intermittent Problem By Using CONSULT Diagnosis Mode1. Turn ignition switch OFF.
Data Link Connector:
2. Connect CONSULT to Data link connector.
3. Turn ignition switch ON.
Diagnostic Procedure 8:
4. Touch "START".
Diagnostic Procedure 8:
5. Touch "AIRBAG".
Diagnostic Procedure 8:
6. Touch "SELF-DIAG [PAST]".
Diagnostic Procedure 8:
7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.
Diagnostic Procedure 8:
If no self-diagnostic failure is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".
Diagnostic Procedure 8:
8. Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.
Diagnostic Procedure 8:
9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to the INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART.
12. Touch BACK key of CONSULT until "SELECT SYSTEM" appears, then turn off CONSULT.
13. Turn ignition switch OFF, then disconnect CONSULT and both battery cables.
14. Repair the system as outlined by the Repair order in INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART, that corresponds to the problem code. For replacement procedure of component parts refer to AIR BAG / SERVICE AND REPAIR.
15. Go to DIAGNOSTIC PROCEDURE 4 for final checking. Procedure 4
DIAG Procedure 8 (Intermittent Code Chart):
INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART (SELF-DIAG[PAST] OR TROUBLE DIAG RECORD)