Turn Signals: Description and Operation

With the hazard switch in the OFF position and the ignition switch in the ON or START position, power is supplied
^ through 10 A fuse (No. (3), located in the fuse block)
^ to hazard switch terminal (2)
^ through terminal (1) of the hazard switch
^ to combination flasher unit terminal (2)
^ through terminal (3) of the combination flasher unit
^ to turn signal switch terminal (1).
Ground is supplied to combination flasher unit terminal (1) through body grounds (M5) and (M57).

LH turn
When the turn signal switch is moved to the LH position, power is supplied from turn signal switch terminal (3) to
^ front turn signal lamp LH terminal (1)
^ rear combination lamp LH terminal (2)
^ combination meter terminal (21).
Ground is supplied to the front turn signal lamp LH terminal (2) through body grounds (E28) and (E42).
Ground is supplied to the rear combination lamp LH terminal (4) through body grounds (B4) , (B13) and (T16).
Ground is supplied to combination meter terminal (22) through body grounds (M5) and (M57).
With power and ground supplied, the combination flasher unit controls the flashing of the LH turn signal lamps.

RH turn
When the turn signal switch is moved to the RH position, power is supplied from turn signal switch terminal (2) to
^ front turn signal lamp RH terminal (1)
^ rear combination lamp RH terminal (2)
^ combination meter terminal (23).
Ground is supplied to the front turn signal lamp RH terminal (2) through body grounds (E28) and (E42).
Ground is supplied to the rear combination lamp RH terminal (4) through body grounds (B4) , (B13) and (T16).
Ground is supplied to combination meter terminal (22) through body grounds (M5) and (M57).
With power and ground supplied, the combination flasher unit controls the flashing of the RH turn signal lamps.

WITH MULTI-REMOTE CONTROL SYSTEM
Power is supplied at all times
^ through 10 A fuse (No. (5), located in the fuse block)
^ to multi-remote control relay-1 terminals (1), (6) and (3)
Ground is supplied to multi-remote control relay-1 terminal (2), when the multi-remote control system is triggered through the smart entrance control unit.
The multi-remote control relay-1 is energized.
Power is supplied through terminal (7) of the multi-remote control relay-1
^ to front turn signal lamp LH terminal (1)
^ to rear combination lamp LH terminal (2)
^ to combination meter terminal (21).
Power is supplied through terminal (5) of the multi-remote control relay-1
^ to front turn signal lamp RH terminal (1)
^ to rear combination lamp RH terminal (2)
^ to combination meter terminal (23).
Ground is supplied to terminal (2) of each front turn signal lamp through body grounds (E28) and (E42)
Ground is supplied to terminal (4) of the rear combination lamps through body grounds (B4) , (B13) and (T16).
Ground is supplied to combination meter terminal (22) through body grounds (M5) and (M57).
With power and ground supplied, the smart entrance control unit controls the flashing of the hazard warning lamps.