Without CONSULT Scan Tool
HOW TO DISPLAY THE TROUBLE CODES1. Drive vehicle over 30 km/h (19 MPH) for at least one minute.
2. Turn ignition switch "OFF".
3. Ground terminal "L" of "Data link connector for CONSULT" with a suitable harness.
4. Turn ignition switch "ON" while grounding terminal "L".
^ Do not depress brake pedal.
5. After 3.0 seconds, the warning lamp starts flashing to indicate the malfunction code number.
NOTE: The indication terminates after five minutes. However, when the ignition switch is turned from "OFF" to "ON", the indication starts flashing again.
6. Verify the location of the malfunction with the malfunction code chart. Then make the necessary repairs following the diagnostic procedures.
7. After the malfunctions are repaired, erase the malfunction codes stored in the control unit.
8. Rerun the self-diagnostic results mode to verify that the malfunction codes have been erased.
9. Disconnect the check terminal from the ground. The self-diagnostic results mode is now complete.
10. Check warning lamp for deactivation after driving vehicle over 30 km/h (19 MPH) for at least one minute.
11. After making certain that warning lamp does not come on, test the ABS in a safe area to verify that it functions properly.