Removal

REMOVAL

CAUTION:
- Before servicing SRS, turn the ignition switch off, disconnect battery ground cable and wait for at least 3 minutes.
- Always work from the side of or under air bag module.





1. Remove connector bracket from air bag module and disconnect inflator connector from body harness air bag connector.
2. Remove instrument panel.





3. Remove the special bolts from left and right sides of front passenger air bag module using the TAMPER RESISTANT TORX (Size T50). Then remove the air bag module from the steering member.

NOTE: Air bag module is heavy and should be supported using both hands during removal.

CAUTION:





- Always place air bag module with pad side facing upward.
- Do not attempt to disassemble air bag module.
- The special bolts are coated with bonding agent. Discard old ones after removal; replace with new ones.
- Do not insert any foreign objects (screwdriver, etc.) into air bag module connector.

Removal - Front Passenger Air Bag Module:

- Replace air bag module if it has been dropped or sustained an impact.
- Do not expose the air bag module to temperatures exceeding 90°C (194°F).
- Do not allow oil, grease or water to come in contact with the air bag module.
- After air bag inflates, the front instrument panel assembly should be replaced if damaged.