Procedure 4
Final Checking After Repairing SRS By Using CONSULT - Diagnosis Mode1. After repairing SRS, connect both battery cables.
2. Connect CONSULT to Data link connector.
3. Turn ignition switch from "OFF" to "ON".
4. Touch "START".
5. Touch "AIRBAG".
6. Touch "SELF-DIAG [CURRENT]".
7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed.
If any problem code is displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 Procedure 2, and repair malfunctioning part completely.
8. Touch "ERASE".
NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction is "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.
Diagnostic Procedure 4 (With Consult):
9. Touch "BACK" key of CONSULT to select "SELF-DIAG [PAST]" in the "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".
10. Check that no self-diagnostic failure is detected on "SELF DIAG [PAST]".
11. Touch "BACK" key of CONSULT until SELECT SYSTEM appears in order to return to User mode from Diagnosis mode, turn oft CONSULT then disconnect CONSULT.
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1 Procedure 1, to check SRS operation by using "AIR BAG" warning lamp with User mode.