Procedure 8
Inspecting SRS Intermittent Problem By Using CONSULT - Diagnosis Mode1. Turn ignition switch "OFF".
2. Connect "CONSULT" to Data link connector.
3. Turn ignition switch "ON".
4. Touch "START".
Self-diagnosis Diagnostic Procedure 8 With Consult:
5. Touch "AIRBAG".
Self-diagnosis Diagnostic Procedure 8 With Consult:
6. Touch "SELF-DIAG [PAST]".
Self-diagnosis Diagnostic Procedure 8 With Consult:
7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.
Self-diagnosis Diagnostic Procedure 8 With Consult:
If no self-diagnostic failure is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".
Self-diagnosis Diagnostic Procedure 8 With Consult:
8. Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.
Self-diagnosis Diagnostic Procedure 8 With Consult:
9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to the INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART.
12. Touch "BACK" key of CONSULT until SELECT SYSTEM appears, then turn off CONSULT
13. Turn ignition switch "OFF", then disconnect CONSULT and both battery cables.
14. Repair the system as outlined by the "Repair order" in INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART, that corresponds to the problem code. For replacement procedure of component parts.
15. Go to DIAGNOSTIC PROCEDURE 4 Procedure 4, for final checking.
Intermittent Problem Diagnostic Code Chart:
INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART